Service Manual

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S3048-ON

1501

To restore the default value, use the no peer-routing-timeout command.

Parameters

value Enter the timeout value in seconds. The range is from 1 to 65535. The default value

is innity.

Command Modes VLT DOMAIN (conf-vlt-domain)

Command History

This guide is platform-specic. For command information about other platforms, refer to the relevant Dell

Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.8(0.0) Introduced on the S3048-ON and S4048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.7(0.0) Added support for default value on the S-Series and Z-Series.

9.5(0.1) Introduced on the Z9500.

9.4(0.0) Added the support for IPV6 / IPV4.

9.2(0.2) Introduced on the Z9000, S4810, and S4820T.

9.0.2.0 Introduced on the S6000.

Usage Information When the timer expires, the software checks to see if the VLT peer is now available. If the VLT peer is not

available, peer-routing is disabled on that peer.

primary-priority

Assign the priority for master election among VLT peers.

Syntax

[no] primary-priority

Parameters

value To congure the primary role on a VLT peer, enter a lower value than the priority

value of the remote peer. The range is from 1 to 65535.

Default 32768

Command Modes VLT DOMAIN