Service Manual

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S3048-ON

1501

To restore the default value, use the no multicast peer-routing timeout command.

Parameters

value Enter the timeout value in seconds. The range is from 1 to 1200. The default is 150.

Command Modes VLT DOMAIN (conf-vlt-domain)

Command History

This guide is platform-specic. For command information about other platforms, refer to the relevant Dell

Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.8(0.0) Introduced on the S3048-ON and S4048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.5(0.1) Introduced on the Z9500.

9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-

Mux (PMUX) mode only.

9.2(0.2) Introduced on the Z9000, S4810, and S4820T.

9.0.2.0 Introduced on the S6000.

peer-link port-channel

Congure the specied port channel as the chassis interconnect trunk between VLT peers in the domain.

Syntax

peer-link port-channel port-channel-number {peer-down-vlan vlan id}

Parameters

port-channel-

number

Enter the port-channel number that acts as the interconnect trunk. The range is

from 1 to 128.

peer-down-vlan

vlan id

Enter the keyword peer-down-vlan then a VLAN ID to congure the VLAN

that the VLT peer link uses when the VLT peer is down.

Defaults Not congured.

Command Modes VLT DOMAIN