Service Manual
Usage Information You must enable the stackable VLAN (using the vlan-stack compatible command) on the VLAN
prior to adding a member to the VLAN.
Related Commands vlan-stack compatible — enables stackable VLAN on a VLAN.
stack-unit stack-group
Congure a stacking group specied by an ID.
Syntax
[no] stack-unit unit-id stack-group stack-group-id
Parameters
unit-id Enter the stack unit ID.
stack-group-id Enter the stack group ID. The range is from 0 to 16.
[no] Use no stack-unit unit-id stack-group stack-id to remove the
current stack group conguration.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.10.2 Introduced on the S4810.
Usage Information
WARNING: The following message displays to conrm the command: All non-default
configurations on the related member ports ports (<ports listed here>)
will be removed. Do you want to continue (y/n)? If you enter “y”, all non-default
congurations on any member ports of the current stack group is removed when the unit is
rebooted.
vlan-stack access
Specify a Layer 2 port or port channel as an access port to the stackable VLAN network.
Syntax
vlan-stack access
To remove access port designation, use the no vlan-stack access command.
Defaults Not congured.
VLAN Stacking
1473