Service Manual
interface-type-
number
• For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet
then the slot/port information.
• For a port channel interface, enter the keywords port-channel then a
number from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
anylocal
Enter the anylocal command to allow the multipoint receive-only tunnel to
decapsulate tunnel packets destined to any local ip address.
Defaults none
Command Modes INTERFACE TUNNEL (conf-if-tu)
Command History
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.4(0.0) Added the tunnel source anylocal command.
9.3(0.0) Introduced on the S4810, S4820T, S6000 and Z9000.
Usage Information
Added an optional keyword “anylocal” to the tunnel source command. The anylocal argument can be used
in place of the ip address or interface, but only with the multipoint receive-only mode tunnels. The tunnel
source anylocal command allows the multipoint receive-only tunnel to decapsulate tunnel packets
addressed to any IPv4 or IPv6 (depending on the tunnel mode) address congured on the switch that is
operationally Up.
Tunneling
1459