Service Manual
Version Description
9.0.2.0 Introduced on the S6000.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
ntp trusted-key
Set a key to authenticate the system to which NTP synchronizes.
Syntax
ntp trusted-key number
To delete the key, use the no ntp trusted-key number command.
Parameters
number Enter a number as the trusted key ID. The range is from 1 to 4294967295.
Defaults Not congured.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.11.1 Introduced on the Z9000.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
Usage Information The number parameter in the ntp trusted-key command must be the same number as the number
parameter in the ntp authentication-key command. If you change the ntp authentication-
key
command, you must also change the ntp trusted-key command.
Related Commands
ntp authentication-key — sets an authentication key for NTP.
ntp authenticate — enables the NTP authentication parameters you set.
System Time and Date
1447