Service Manual
debug ntp
Display network time protocol (NTP) transactions and protocol messages for troubleshooting.
Syntax
debug ntp {adjust | all | authentication | events | loopfilter | packets |
select | sync}
To disable debugging of NTP transactions, use the no debug ntp {adjust | all |
authentication | events | loopfilter | packets | select | sync} command.
Parameters
adjust Enter the keyword adjust to display information on NTP clock adjustments.
all Enter the keyword all to display information on all NTP transactions.
authentication Enter the keyword authentication to display information on NTP
authentication transactions.
events Enter the keyword events to display information on NTP events.
looplter Enter the keyword loopfilter to display information on NTP local clock
frequency.
packets Enter the keyword packets to display information on NTP packets.
select Enter the keyword select to display information on the NTP clock selection.
sync Enter the keyword sync to display information on the NTP clock synchronization.
Command Modes EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
1440
System Time and Date