Service Manual

Example
Dell(conf)#protocol spanning-tree 0
Dell(config-stp)#
Related Commands disable — disables spanning tree group 0. To enable spanning tree group 0, use the no disable
command.
show cong
Display the current conguration for the mode. Only non-default values display.
Syntax
show config
Command Modes SPANNING TREE
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.7.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Example
Dell(config-stp)#show config
protocol spanning-tree 0
no disable
Dell(config-stp)#
show spanning-tree 0
Display the spanning tree group conguration and status of interfaces in the spanning tree group.
Syntax
show spanning-tree 0 [active | brief | guard | interface interface | root |
summary]
Parameters
0 Enter 0 (zero) to display information about that specic spanning tree group.
active (OPTIONAL) Enter the keyword active to display only active interfaces in
spanning tree group 0.
1430
Spanning Tree Protocol (STP)