Service Manual
Version Description
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 E-Series Only: Added the percentage decimal value option.
6.5.1.0 Introduced on the E-Series.
storm-control multicast (Conguration)
Congure the packets per second (pps) of multicast trac allowed into the C-Series and S-Series networks only.
Syntax
storm-control multicast packets_per_second in
To disable storm-control for multicast trac into the network, use the no storm-control multicast
packets_per_second in command.
Parameters
packets_per_secon
d in
Enter the packets per second of multicast trac allowed into the network. The
range is from 0 to 33554368.
Defaults none
Command Modes CONFIGURATION (conf)
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-
Mux (PMUX) mode only.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the C-series and S-Series.
Usage Information Broadcast trac (all 0xFs) should be counted against the broadcast storm control meter, not against the
multicast storm control meter. It is possible, however, that some multicast control trac may get dropped
when storm control thresholds are exceeded.
Storm Control
1419