Service Manual

stack-group-id Enter the stack group ID.
Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S3048–ON.
9.7(0.0) Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.7.1 Introduced on the S4810.
8.3.12.0 Reset command mode from EXEC to CONFIGURATION.
Usage Information The following message displays to conrm the command.
Setting ports Fo 1/60 as stack group will make their interface configs
obsolete after a reload.[confirm yes/no]: If “y” is entered, all non-
default configurations on any member ports of the current stack group will
be removed when the unit is rebooted.
NOTE: Any scripts used to streamline the stacking conguration process must be updated to
reect the Command Mode change from EXEC Privilege to CONFIGURATION to allow the scripts
to work correctly.
upgrade system stack-unit
Copy the boot image or Dell Networking OS from the management unit to one or more stack members.
Syntax
upgrade {boot | system} stack-unit {all | stack-unit-number | A | B}
Parameters
boot Enter the keyword boot to copy the boot image from the management unit to the
designated stack members.
system Enter the keyword system to copy the Dell Networking OS image from the
management unit to the designated stack members.
stack-unit Enter the stack-unit number. The range is from 1 to 6.
all Enter the keyword all to copy the designated image to all stack members.
A Enter the keyword A to upgrade all stacked units in System A ( only).
B Enter the keyword B to upgrade all stacked units in System B ( only).
Defaults none
Command Modes EXEC
1412
Stacking