Service Manual

3/27/1 10 up down
3/28/1 10 up down
Example (Topology)
Dell#show system stack-port topology
Topology: Daisy chain
Interface Connection
---------------------
1/25 3/25
1/26
1/27
1/28
3/25 1/25
3/26
3/27
3/28
Related Commands
• reset stack-unit – resets the designated stack member.
• show hardware stack-unit – displays the data plane or management plane input and output statistics of
the designated component of the designated stack member.
• show system (S-Series and Z-Series) – displays the current status of all stack members or a specic
member.
stack-unit priority
Congure the ability of a switch to become the management unit of a stack.
Syntax
stack-unit stack-unit number priority 1-14
Parameters
stack-number Enter the stack member unit identier.
1–14 This preference parameter allows you to specify the management priority of one
backup switch over another, with 0 the lowest priority and 14 the highest. The
switch with the highest priority value is chosen to become the management unit if
the active management unit fails or on the next reload.
Defaults 0
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048–ON and S4048–ON.
9.7(0.0) Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
1410
Stacking