Service Manual

logging on — enables logging.
logging history
Specify which messages are logged to the history table of the switch and the SNMP network management station (if congured).
Syntax
logging history level
To return to the default values, use the no logging history command.
Parameters
level Indicate a value from 0 to 7 or enter one of the following equivalent words:
emergencies, alerts, critical, errors, warnings, notifications,
informational, or debugging. The default is 4 or warnings.
Defaults warnings or 4
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage Information When you congure the snmp-server trap-source command, the system messages logged to the
history table are also sent to the SNMP network management station.
Related Commands
show logging — displays information logged to the history buer.
logging history size
Specify the number of messages stored in the Dell Networking logging history table.
Syntax
logging history size size
To return to the default values, use the no logging history size command.
1388
Simple Network Management Protocol (SNMP) and Syslog