Service Manual

To return to the default sampling rate, use the no sflow sample-rate command.
Parameters
value Enter the sampling rate value. For the C-Series and S-Series, the range is from 256
to 8388608 packets. Enter values in powers of 2 only; for example, 4096, 8192,
16384, etc. The default is 32768 packets.
Defaults The Global default sampling.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on S-Series Stacking.
8.1.1.0 Introduced on the E-Series ExaScale.
7.7.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Usage Information This command changes the sampling rate for an interface. By default, the sampling rate of an interface is set
to the same value as the current global default sampling rate. If the value entered is not a correct power of
2, the command generates an error message with the previous and next power-of-2 value. Select one of
these two number and re-enter the command.
Related Commands sow sample-rate (Global) — changes the sampling rate globally.
show sow
Display the current sFlow conguration.
Syntax
show sflow [interface]
Parameters
interface (OPTIONAL) Enter the following keywords and slot/port or number information:
• For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet
then the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
1354
sFlow