Service Manual

sow sample-rate (Global)
Change the global default sampling rate.
Syntax
sflow sample-rate value
To return to the default sampling rate, use the no sflow sample-rate command.
Parameters
value Enter the sampling rate value. For the C-Series and S-Series, the range is from 256
to 8388608 packets Enter values in powers of 2 only; for example, 4096, 8192,
16384, and so on. The default is 32768 packets.
Defaults 32768 packets
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on S-Series Stacking.
8.1.1.0 Introduced on the E-Series ExaScale.
7.7.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
7.4.1.0 Introduced on the E-Series.
Usage Information Sample-rate is the average number of packets skipped before the sample is taken. This command changes
the global default sampling rate. You can congure an interface to use a dierent sampling rate than the
global sampling rate. If the value entered is not a correct power of 2, the command generates an error
message with the previous and next power of 2 value. Select one of these two packet numbers and re-enter
the command.
Related Commands sow sample-rate (Interface) — changes the interface sampling rate.
sow sample-rate (Interface)
Change the interface default sampling rate.
Syntax
sflow sample-rate value
sFlow
1353