Service Manual

5. Verify the conguration has been applied to the console or VTY line.
Related Commands login authentication, password, radius-server host, tacacs-server host
enable
Enter EXEC Privilege mode or any other privilege level congured. After entering this command, you may need to enter a password.
Syntax
enable [level]
Parameters
level (OPTIONAL) Enter a number for a privilege level of Dell Networking OS. The range
is from 0 to 15.
Defaults 15
Command Modes EXEC
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.0) Added support for roles on the Z9000, S6000, S4820T, S4810, and MXL.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series Original command.
Usage Information Users entering EXEC Privilege mode or any other congured privilege level can access conguration
commands. To protect against unauthorized access, use the enable password command to congure a
password for the enable command at a specic privilege level. If no privilege level is specied, the default
is privilege level
15.
NOTE: If you are authorized for the EXEC Privilege mode by your role, you do not need to enter an
enable password.
Related Commands enable password — congures a password for the enable command and to access a privilege level.
Security
1335