Service Manual

NOTE: If you enable FIPS mode, you can only select version 2.
Defaults
• Default listening port is 22.
• Default cipher list is 3des-cbc,aes128-cbc,aes192-cbc,aes256-cbc,aes128-ctr,aes192-ctr,aes256-ctr.
• When FIPS is enabled, the default is hmac-sha1-96.
• When FIPS is not enabled, the default is hmac-md5,hmac-md5-96,hmac-sha1,hmac-sha1-96,hmac-
sha2-256,hmac-sha2-256-96.
• When FIPS is enabled, the default is die-hellman-group14-sha1.
• When FIPS is not enabled, the default is die-hellman-group-exchange-sha1,die-hellman-group1-
sha1,die-hellman-group14-sha1.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.5(0.0) Introduced the cipher, kex and mac options on the Z9000, S6000, S4820T,
S4810, and MXL.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
Usage Information This command enables the SSH server and begins listening on a port. If a port is not specied, listening is on
SSH default port 22.
NOTE: Starting with Dell Networking OS Release 9.2(0.0), SSH server is enabled by default.
Example
Dell# conf
Dell(conf)# ip ssh server port 45
Dell(conf)# ip ssh server enable
Dell#
Related Commands show ip ssh — displays the ssh information.
Security
1319