Service Manual

Parameters
group-name Enter the name of the TACACS server group.
Defaults Not congured.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.4.(0.0) Introduced on the S-Series and Z-Series.
Usage Information You can associate a TACACS server group with a VRF.
Example
Dell(conf)#tacacs-server group group1
Dell(conf-tacacs-group)#tacacs-server host 1.1.1.1 key secret
Dell(conf-tacacs-group)#tacacs-server host 2.2.2.2 key secret
Dell(conf-tacacs-group)#tacacs-server vrf vrf1 source-interface
gigabitethernet 1/40
Dell(conf-tacacs-group)#show config
!
tacacs-server group group1
tacacs-server vrf vrf1 source-interface GigabitEthernet 1/40
tacacs-server host 1.1.1.1 key 7 9a2f3ec0c65c6f41
tacacs-server host 2.2.2.2 key 7 9a2f3ec0c65c6f41
Dell(conf-tacacs-group)#
Related Commands
aaa authentication login — species the login authentication method.
tacacs-server key — congures a TACACS+ key for the TACACS server.
tacacs-server host
Specify a TACACS+ host.
Syntax
tacacs-server host {hostname | ipv4-address | ipv6-address} [port number]
[timeout seconds] [key key]
Parameters
hostname Enter the name of the TACACS+ server host.
ipv4-address | ipv6-
address
Enter the IPv4 address (A.B.C.D) or IPv6 address (X:X:X:X::X) of the TACACS+
server host.
port number (OPTIONAL) Enter the keyword port then a number as the port to be used by
the TACACS+ server. The range is from zero (0) to 65535. The default is 49.
timeout seconds (OPTIONAL) Enter the keyword timeout then the number of seconds the switch
waits for a reply from the TACACS+ server. The range is from 0 to 1000. The
default is 10 seconds.
1292
Security