Service Manual

radius-server retransmit
Congure the number of times the switch attempts to connect with the congured RADIUS host server before declaring the
RADIUS host server unreachable.
Syntax
radius-server retransmit retries
To congure zero retransmit attempts, use the no radius-server retransmit command.
To return to the default setting, use the radius-server retransmit 3 command.
Parameters
retries Enter a number of attempts that FTOS tries to locate a RADIUS server. The range
is from zero (0) to 100. The default is 3 retries.
Defaults 3 retries
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.2.1.0 Introduced on the E-Series.
Related Commands radius-server host — congures a RADIUS host.
radius-server timeout
To reply to a request, congure the amount of time the RADIUS client (the switch) waits for a RADIUS host server .
Syntax
radius-server timeout seconds
To return to the default value, use the no radius-server timeout command.
Parameters
seconds Enter the number of seconds between an unsuccessful attempt and the Dell
Networking OS times out. The range is from zero (0) to 1000 seconds. The default
is 5 seconds.
Defaults 5 seconds
Command Modes CONFIGURATION
1288
Security