Service Manual

Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
Usage Information
To control access to command modes, use this command to dene a password for a level and use the
privilege level (CONFIGURATION mode) command.
Passwords must meet the following criteria:
• Start with a letter, not a number.
• Passwords can have a regular expression as the password. To create a password with a regular
expression in it, use CNTL + v prior to entering regular expression. For example, to create the password
abcd]e, you type “abcd CNTL v ]e”. When the password is created, you do not use the CNTL + v
key combination and enter “abcd]e”.
NOTE: The question mark (?) and the tilde (~) are not supported characters.
Related Commands
show running-cong — views the current conguration.
privilege level (CONFIGURATION mode) — controls access to the command modes within the switch.
enable restricted
Allows Dell Networking technical support to access restricted commands.
Syntax
enable restricted [encryption-type] password
To disallow access to restricted commands, use the no enable restricted command.
Parameters
encryption-type
(OPTIONAL) Enter the number 7 as the encryption type.
Enter 7 followed a text string as the hidden password. The text string must be a
password that was already encrypted by a Dell Networking router.
Use this parameter only with a password that you copied from the show
running-config le of another Dell Networking router.
password Enter a text string, up to 32 characters long, as the clear text password.
Defaults Not congured.
1270
Security