Service Manual

Parameters
number Assign an event number in integer format. The range is from 1 to 65535. You must
ensure that the value you enter is unique in the RMON event table.
log (OPTIONAL) Enter the keyword log to generate an RMON event log. This option
sets the eventType to either log or log-and-snmptrap in the RMON event table.
The default is None.
trap community (OPTIONAL) Enter the keyword trap followed by the SNMP community string to
generate SNMP traps for an RMON event entry. This option sets the eventType to
either snmptrap or log-and-snmptrap in the RMON event table. In addition to the
SNMP traps, this option also generates a syslog.
description string (OPTIONAL) Enter the keyword description then a string describing the
event.
owner name (OPTIONAL) Enter the keyword owner then the name of the owner of this event.
Defaults As noted in the Parameters section.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048–ON and S4048–ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
rmon hc-alarm
Set an alarm on any MIB object.
S3048–ON
Syntax
rmon hc-alarm number variable interval {delta | absolute} rising-threshold
value event-number falling-threshold value event-number [owner string]
To disable the alarm, use the no rmon hc-alarm number command.
Remote Monitoring (RMON)
1229