Service Manual

Version Description
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
pre- 6.2.1.1 Introduced on the E-Series.
Usage Information To enable RIP, assign a network address using the network command.
Example
Dell(conf)#router rip
Dell(conf-router_rip)#
Related Commands
network — enables RIP.
exit — returns to CONFIGURATION mode.
show cong
Display the changes you made to the RIP conguration. The default values are not shown.
S3048–ON
Syntax
show config
Command Modes ROUTER RIP
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
pre- 6.2.1.1 Introduced on the E-Series.
Example
Dell(conf-router_rip)#show config
!
Routing Information Protocol (RIP)
1219