Service Manual

Defaults Disabled. Metric: 1.

Command Modes ROUTER RIP

Command History

This guide is platform-specic. For command information about other platforms, refer to the relevant Dell

Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.8(0.0) Introduced on the S3048-ON and S4048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

7.8.1.0 Introduced on the S-Series.

7.6.1.0 Introduced on the C-Series.

pre- 6.2.1.1 Introduced on the E-Series.

Usage Information The default route must be present in the switch routing table for the default-information

originate command to take eect.

default-metric

Change the default metric for routes. To ensure that all redistributed routes use the same metric value, use this command with the

redistribute command.

S3048–ON

Syntax

default-metric number

To return the default metric to the original values, use the no default-metric command.

Parameters

number Specify a number. The range is from 1 to 16. The default is 1.

Defaults 1