Service Manual
• For a VLAN, enter the keyword vlan then a number from 1 to 4094.
database (OPTIONAL) Enter the keyword database to display messages when there is a
change to the RIP database.
events (OPTIONAL) Enter the keyword events to debug only RIP protocol changes.
trigger (OPTIONAL) Enter the keyword trigger to debug only RIP trigger extensions.
Command Modes EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
pre- 6.2.1.1 Introduced on the E-Series.
default-information originate
Generate a default route for the RIP trac.
S3048–ON
Syntax
default-information originate [always] [metric metric-value] [route-map
map-name]
To return to the default values, use the no default-information originate command.
Parameters
always (OPTIONAL) Enter the keyword always to enable the switch software to always
advertise the default route.
metric metric-value (OPTIONAL) Enter the keyword metric then a number as the metric value. The
range is from 1 to 16. The default is 1.
route-map map-
name
(OPTIONAL) Enter the keywords route-map then the name of a congured
route-map.
Routing Information Protocol (RIP)
1201