Service Manual

wred-prole
Create a WRED prole and name the prole.
S3048–ON
Syntax
wred-profile wred-profile-name
To remove an existing WRED prole, use the no wred-profile command.
Parameters
wred-prole-name
Enter your WRED prole name in character format (32 character maximum). Or
use one of the pre-dened WRED prole names. You can congure up to 26 WRED
proles plus the ve pre-dened proles, for a total of 31 WRED proles.
Pre-dened Proles: wred_drop, wred-ge_y, wred_ge_g, wred_teng_y,
wred_teng_g.
Defaults The ve pre-dened WRED proles. When you congure a new prole, the minimum and maximum
threshold defaults to predened wred_ge_g values.
If green prole is applied, default yellow also take eect and vice-versa.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Usage Information Use the default pre-dened proles or congure your own prole. You cannot delete the pre-dened proles
or their default values. This command enables WRED conguration mode —(conf-wred).
Related Commands threshold — species the minimum and maximum threshold values of the WRED prole.
Quality of Service (QoS)
1193