Service Manual

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S3048-ON

1171

Parameters

policy-map-name Enter the name for the policy map in character format (32 characters maximum).

You can identify an existing policy map or name one that does not yet exist.

layer2 (OPTIONAL) Enter the keyword layer2 to specify a Layer 2 Class Map. The

default is Layer 3.

Defaults Layer 3

Command Modes INTERFACE

Command History

This guide is platform-specic. For command information about other platforms, refer to the relevant Dell

Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.8(0.0) Introduced on the S3048-ON and S4048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

Usage Information You can attach a single policy-map to one or more interfaces to specify the service-policy for those

interfaces. A policy map attached to an interface can be modied.

NOTE: The service-policy commands are not allowed on a port channel. The service-

policy input policy-map-name command and the service-class dynamic dot1p

command are not allowed simultaneously on an interface.

Related Commands policy-map-input — creates an input policy map.

service-policy output

Apply an output policy map to the selected interface.

S3048–ON

Syntax

service-policy output policy-map-name

To remove the output policy map from the interface, use the no service-policy output policy-

map-name command.