Service Manual

To remove an existing output QoS policy, use the no qos-policy-output qos-policy-name
command.
Parameters
qos-policy-name Enter your output QoS policy name in character format (32 characters maximum).
Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Usage Information
Use this command to specify the name of the output QoS policy. Once output policy is specied, rate-
shape, scheduler strict, bandwidth-percentage, and WRED can be dened. This command enables the qos-
policy-output conguration mode—(conf-qos-policy-out).
Related Commands
bandwidth-percentage — assigns percentage of bandwidth to the class/queue.
wred — assigns yellow or green drop precedence.
queue egress
Assign a WRED Curve to all eight egress Multicast queues or designate the percentage for the Multicast bandwidth queue.
Syntax
queue egress multicast linecard {slot number port-set number | all} [wred-
profile name | multicast-bandwidth percentage]
To return to the default, use the no queue egress multicast linecard {slot number
port-set number | all} [wred-profile name | multicast-bandwidth percentage]
command.
Parameters
linecard number Enter the keyword linecard then the line card slot number.
port-set number Enter the keywords port-set then the line card’s port pipe. The range is from 0
or 1.
all Enter the keyword all to apply to all line cards.
1172
Quality of Service (QoS)