Service Manual
Version Description
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Usage Information The input policy map is used to classify incoming trac to dierent ows using class-map, QoS policy, or
incoming packets DSCP. This command enables Policy-Map-Input Conguration mode (conf-policy-map-in).
Related Commands
service-queue — assigns a class map and QoS policy to dierent queues.
service-policy input — applies an input policy map to the selected interface.
policy-map-output
Create an output policy map.
S3048–ON
Syntax
policy-map-output policy-map-name
To remove a policy map, use the no policy-map-output policy-map-name command.
Parameters
policy-map-name Enter the name for the policy map in character format (32 characters maximum).
Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Usage Information To assign trac to dierent ows using QoS policy, use the Output Policy map. This command enables
Policy-Map-Output Conguration mode (conf-policy-map-out).
Related Commands
service-queue — assigns a class map and QoS policy to dierent queues.
policy-aggregate — allows an aggregate method of conguring per-port QoS using policy maps.
service-policy output — applies an output policy map to the selected interface.
1170
Quality of Service (QoS)