Service Manual

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S3048-ON

1161

match ip vrf

Uses a VRF as the match criterion for an L3 class map.

S3048–ON

Syntax

match ip vrf vrf-id

To remove VRF as the match criterion, use the no match ip vrf vrf-id command.

Parameters

vlan vlan-id Enter the keyword vrf and then the ID of the VRF. The range is from 1 to 63.

Defaults none

Command Modes CONF-CLASS-MAP

Command History

This guide is platform-specic. For command information about other platforms, refer to the relevant Dell

Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.8(0.0) Introduced on the S3048-ON and S4048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.5.(0.0) Introduced on the Z9500.

9.4.(0.0) Introduced on the S-Series and Z-Series.

Usage Information To access this command, enter the class-map command. After the class map is identied, you can

congure the match criteria.

Use this command to match an IP class-map against a single VRF ID .

Related Commands class-map — identies the class map.

match mac access-group

Congure a match criterion for a class map, based on the contents of the designated MAC ACL.

S3048–ON

Syntax

match mac access-group {mac-acl-name}