Service Manual
Usage Information
To access this command, enter the class-map command. After the class map is identied, you can
congure the match criteria.
The match ip precedence command and the match ip dscp command are mutually exclusive.
Up to eight precedence values can be matched in one match statement. For example, to indicate the IP
precedence values 0 1 2 3, enter either the match ip precedence 0-3 or match ip precedence
0,1,2,3 command.
NOTE: Only one of the IP precedence values must be a successful match criterion, not all of the
specied IP precedence values must match.
Related Commands
class-map — identies the class map.
match ip vlan
Uses a VLAN as the match criterion for an L3 class map.
S3048–ONS3048–ON
Syntax
match ip vlan vlan-id
To remove VLAN as the match criterion, use the no match ip vlan vlan-id command.
Parameters
vlan vlan-id Enter the keyword vlan and then the ID of the VLAN. The range is from 1 to 4094.
Defaults none
Command Modes CONF-CLASS-MAP
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5.(0.0) Introduced on the Z9500.
9.4.(0.0) Introduced on the S-Series and Z-Series.
Usage Information To access this command, enter the class-map command. After the class map is identied, you can
congure the match criteria.
Use this command to match an IP class-map against a single VLAN ID .
Related Commands class-map — identies the class map.
Quality of Service (QoS)
1165