Service Manual

Parameters
queue Enter a value from 0 to 7.
Defaults For each dot1p Priority, the default CoS queue value is:
• Dot1p Priority : 0 1 2 3 4 5 6 7
• Queue : 2 0 1 3 4 5 6 7
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Usage Information To apply dot1p-queue-mapping, use the service-class dynamic dot1p command.
Related Commands show qos dot1p-queue-mapping — displays the dot1p priority to queue mapping on the switch.
service-class dynamic dot1p
Honor all 802.1p markings on incoming switched trac on an interface (from INTERFACE mode) or on all interfaces (from
CONFIGURATION mode). A CONFIGURATION mode entry supersedes an INTERFACE mode entry.
S3048–ON
Syntax
service-class dynamic dot1p
To return to the default setting, use the no service-class dynamic dot1p command.
Defaults All dot1p trac is mapped to Queue 0 unless you enable the service-class dynamic dot1p
command. The default mapping is as follows:
dot1p Queue ID
0 0
1 0
2 0
3 1
4 2
5 3
6 3
1156
Quality of Service (QoS)