Service Manual

switchport mode private-vlan
Set PVLAN mode of the selected port.
S3048
Syntax
[no] switchport mode private-vlan {host | promiscuous | trunk}
To remove PVLAN mode from the selected port, use the no switchport mode private-vlan
command.
Parameters
host Enter the keyword host to congure the selected port or port channel as an
isolated interface in a PVLAN.
promiscuous Enter the keyword promiscuous to congure the selected port or port channel
as an promiscuous interface.
trunk Enter the keyword trunk to congure the selected port or port channel as a trunk
port in a PVLAN.
Defaults Disabled.
Command Modes INTERFACE
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048–ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the C-Series and S-Series.
Usage Information
The assignment of the various PVLAN port types to port and port channel (LAG) interfaces is shown in the
following example.
Example
Dell#conf
Dell(conf)#interface GigabitEthernet 2/1
Dell(conf-if-gi-2/1)#switchport mode private-vlan promiscuous
Dell(conf)#interface GigabitEthernet 2/2
Dell(conf-if-gi-2/2)#switchport mode private-vlan host
Dell(conf)#interface GigabitEthernet 2/3
Dell(conf-if-gi-2/3)#switchport mode private-vlan trunk
Dell(conf)#interface port-channel 10
Dell(conf-if-gi-2/3)#switchport mode private-vlan promiscuous
Private VLAN (PVLAN)
1135