Service Manual

private-vlan mapping secondary-vlan
Map secondary VLANs to the selected primary VLAN.
S3048
Syntax
[no] private-vlan mapping secondary-vlan vlan-list
To remove specic secondary VLANs from the conguration, use the no private-vlan mapping
secondary-vlan vlan-list command syntax.
Parameters
vlan-list Enter the list of secondary VLANs to associate with the selected primary VLAN.
The list can be in comma-delimited or hyphenated-range format, following the
convention for the range input.
Defaults none
Command Modes INTERFACE VLAN
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048–ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the C-Series and S-Series.
Usage Information The list of secondary VLANs can be:
Specied in comma-delimited or hyphenated-range format.
Specied with this command even before they have been created.
Amended by specifying the new secondary VLAN to be added to the list.
Related Commands
private-vlan mode — sets the mode of the selected VLAN to community, isolated, or primary.
switchport mode private-vlan — sets PVLAN mode of the selected port.
1134
Private VLAN (PVLAN)