Service Manual

private-vlan mode
Set PVLAN mode of the selected VLAN to community, isolated, or primary.
S3048
Syntax
[no] private-vlan mode {community | isolated | primary}
To remove the PVLAN conguration, use the no private-vlan mode {community | isolated
| primary} command syntax.
Parameters
community Enter the keyword community to set the VLAN as a community VLAN.
isolated Enter the keyword isolated to congure the VLAN as an isolated VLAN.
primary Enter the keyword primary to congure the VLAN as a primary VLAN.
Defaults none
Command Modes INTERFACE VLAN
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048–ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the C-Series and S-Series.
Usage Information The VLAN:
• can be in only one mode, either community, isolated, or primary.
• mode ode to community or isolated even before associating it to a primary VLAN. This secondary
VLAN continues to work normally as a normal VLAN even though it is not associated to a primary VLAN.
(A syslog message indicates this.)
• must not have a port in it when VLAN mode is being set.
Only ports (and port channels) congured as promiscuous, host, or PVLAN trunk ports (as previously
described) can be added to the PVLAN. No other regular ports can be added to the PVLAN.
After using this command to congure a VLAN as a primary VLAN, use the private-vlan mapping
secondary-vlan command to map secondary VLANs to this VLAN.
Related Commands
private-vlan mapping secondary-vlan — maps secondary VLANs to the selected primary VLAN.
switchport mode private-vlan — sets PVLAN mode of the selected port.
Private VLAN (PVLAN)
1133