Service Manual

Version Description
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Usage Information The monitor command is saved in the running conguration at Monitor Session mode level and can be
restored after a chassis reload.
Example
Dell#show monitor session
SessID Source Destination Dir Mode Source IP
Dest IP DSCP TTL
------ ------ ----------- --- ---- ---------
-------- ---- ---
0 Gi 1/12 remote-ip rx Flow 1.1.1.1
7.1.1.2 0 255
0 Po 1 remote-ip tx Flow 1.1.1.1
7.1.1.2 0 255
1 Vl 11 remote-ip rx Flow 5.1.1.1
3.1.1.2 0 255
Related Command
show monitor session — displays the monitor session.
show running-cong monitor session — displays the running conguration of a monitor session.
rate-limit
Congure the rate-limit to limit the mirrored packets.
Syntax
rate-limit limit
To remove the limit, use the no rate-limit limit command.
Parameters
limit Enter the rate-limit value. The range is from 0 to 40000 Megabits per second.
Defaults 60
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S4810, S4820T, S5000, S6000, S6000-ON, Z9500, S3048-ON
and S4048-ON.
Related Commands
monitor session — enables a monitoring session.
show monitor session — displays the monitor session.
Port Monitoring
1125