Service Manual

ip pim query-interval
Change the frequency of PIM Router-Query messages.
Syntax
ip pim query-interval seconds
To return to the default value, use the no ip pim query-interval seconds command.
Parameters
seconds Enter a number as the number of seconds between router query messages. The
range is from 0 to 65535. The default is 30 seconds.
Defaults 30 seconds
Command Modes INTERFACE
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.8.1.0 Introduced on the C-Series for the port-channels and the S-Series.
ip pim register-lter
To prevent a PIM source DR from sending register packets to an RP for the specied multicast source and group, use this feature.
Syntax
ip pim [vrf vrf-name] register-filter access-list
To return to the default, use the no ip pim [vrf vrf-name] register-filter access-list
command.
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of the VRF.
NOTE: Applies to specic VRF if input is provided, else applies to Default
VRF.
access-list Enter the name of an extended access list. Maximum 16 characters.
Defaults Not congured.
1102
PIM-Sparse Mode (PIM-SM)