Service Manual

39
Policy-based Routing (PBR)
Policy-based routing (PBR) allows you to apply routing policies to specic interfaces. To enable PBR, create a redirect list and apply it
to the interface. After the redirect list is applied to the interface, all trac passing through the interface is subject to the rules
dened in the redirect list. PBR is supported by the Dell Networking Operating System (OS).
You can apply PBR to physical interfaces and logical interfaces (such as a link aggregation group [LAG] or virtual local area network
[VLAN]). Trace lists and redirect lists do not function correctly when you congure both in the same conguration.
NOTE: Apply PBR to Layer 3 interfaces only.
NOTE: For more information , refer to Content Addressable Memory (CAM) chapter.
description
Add a description to this redirect list.
Syntax
description {description}
To remove the description, use the no description {description} command.
Parameters
description Enter a description to identify the IP redirect list (16 characters maximum).
Defaults none
Command Modes REDIRECT-LIST
Command History
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048–ON.
9.7(0.0) Introduced on the S6000-ON.
9.4(0.0) Introduced on the S4810, S4820T, S6000, and Z9000.
8.4.2.1 Introduced on the C-Series and S-Series.
8.4.2.0 Introduced on the E-Series Tera Scale.
7.7.1.0 Introduced on the E-Series ExaScale.
Related Commands ip redirect-list – enables an IP Redirect List.
Policy-based Routing (PBR)
1085