Service Manual
holdtime Enter a number as the hold time. The range is from 0 to 4294967295. The default
is 10 seconds.
Defaults
• delay = 5 seconds
• holdtime = 10 seconds
Command Modes ROUTER OSPFv3 for OSPFv3
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S6000-ON, S6000, S4820T, S4810, S5000, S3048-ON and
S4048-ON.
Usage Information Setting the delay and holdtime parameters to a low number enables the switch to an alternate path quickly
but requires more CPU usage.
Example
Dell#conf
Dell(conf)#ipv6 router ospf 1
Dell(conf-ipv6-router_ospf)#timer spf 2 5
Dell(conf-ipv6-router_ospf)#
Dell(conf-ipv6-router_ospf)#show config
!
ipv6 router ospf 1
timers spf 2 5
Dell(conf-ipv6-router_ospf)#
Dell(conf-ipv6-router_ospf)#end
Dell#
1084
Open Shortest Path First (OSPFv2 and OSPFv3)