Service Manual

Parameters
process-id Enter the OSPF Process ID to show a specic process. If no Process ID is entered,
command applies only to the rst OSPF process.
Defaults none
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Added support for Multi-Process OSPF.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series and E-Series.
Usage Information
This command is useful in isolating routing problems between the OSPF and the RTM. For example, if a
route is missing from the RTM/FIB but is visible from the display output of this command, the problem is
with downloading the route to the RTM.
This command has the following limitations:
• The display output is sorted by prexes; intra-area ECMP routes are not displayed together.
• For Type 2 external routes, Type 1 cost is not displayed.
NOTE: Starting with Version 9.4(0.0), the loopback IP address advertised to the neighbor is not
displayed in the output because they are not accounted as inactive OSPF routes, whereas the
loopback IP address is displayed until Dell Networking OS Version 9.3(0.0). Starting with Version
9.4(0.0), the show ip ospf routes command displays the interface and area ID information of
connected networks in addition to the other settings, whereas these details are not displayed until
Dell Networking OS Version 9.3(0.0). Starting with Version 9.4(0.0), the metric of E2 routes in the
output is displayed as an external metric, whereas until Dell Networking OS Version 9.3(0.0), the
number of hops to the ASBR for E2 routes are displayed in the output.
Example
Dell#show ip ospf 100 route
Prefix Cost Nexthop Interface Area Type
1.1.1.1 1 0.0.0.0 Lo 0 0 Intra-Area
3.3.3.3 2 13.0.0.3 Gi 1/47 1 Intra-Area
13.0.0.0 1 0.0.0.0 Gi 1/47 0 Intra-Area
150.150.150.0 2 13.0.0.3 Gi 1/47 - External
Open Shortest Path First (OSPFv2 and OSPFv3)
1045