Service Manual

Version Description
pre- 6.1.1.1 Introduced on the E-Series.
network area
Dene which interfaces run OSPF and the OSPF area for those interfaces.
S3048–ON
Syntax
network ip-address mask area area-id
To disable an OSPF area, use the no network ip-address mask area area-id command.
Parameters
ip-address Specify a primary or secondary address in dotted decimal format. The primary
address is required before adding the secondary address.
mask Enter a network mask in /prex format. (/x)
area-id Enter the OSPF area ID as either a decimal value or in a valid IP address. Decimal
value range is from 0 to 65535. IP address format is dotted decimal format A.B.C.D.
NOTE: If the area ID is smaller than 65535, it is converted to a decimal
value. For example, if you use an area ID of 0.0.0.1, it is converted to 1.
Command Modes ROUTER OSPF
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced to all platforms.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre- 6.1.1.1 Introduced on the E-Series.
Usage Information
To enable OSPF on an interface, the network area command must include, in its range of addresses, the
primary IP address of an interface.
NOTE: An interface can be attached only to a single OSPF area.
1014
Open Shortest Path First (OSPFv2 and OSPFv3)