Service Manual

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S3048-ON

1011

Version Description

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

7.8.1.0 Added support for Multi-Process OSPF.

7.6.1.0 Introduced on the S-Series.

7.5.1.0 Introduced on the C-Series.

pre- 6.1.1.1 Introduced on the E-Series.

maximum-paths

Enable the software to forward packets over multiple paths.

S3048–ON

Syntax

maximum-paths number

To disable packet forwarding over multiple paths, use the no maximum-paths command.

Parameters

number Specify the number of paths. The range for OSPFv2 is from 1 to 64. The default for

OSPFv2 is 4 paths. The range for OSPFv3 is from 1 to 64. The default for OSPFv3

is 8 paths.

Defaults 4

Command Modes ROUTER OSPF for OSPFv2

ROUTER OSPFv3 for OSPFv3

Command History

This guide is platform-specic. For command information about other platforms, refer to the relevant Dell

Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.8(0.0) Introduced on the S3048-ON and S4048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0 Introduced on the S6000.

9.1(0.0) Introduced support for OSPFv3 on the S4810 and Z9000.