Service Manual

Version Description
7.5.1.0 Introduced on the C-Series.
pre- 6.1.1.1 Introduced on the E-Series.
ip ospf auth-change-wait-time
OSPF provides a grace period while OSPF changes its interface authentication type. During the grace period, OSPF sends out
packets with new and old authentication scheme until the grace period expires.
S3048–ON
Syntax
ip ospf auth-change-wait-time seconds
To return to the default, use the no ip ospf auth-change-wait-time command.
Parameters
seconds Enter the seconds. The range is from 0 to 300.
Defaults zero (0) seconds.
Command Modes INTERFACE
Command History
This guide is platform-specic. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre- 6.1.1.1 Introduced on the E-Series.
ip ospf authentication-key
Enable authentication and set an authentication key on OSPF trac on an interface.
S3048–ON
Syntax
ip ospf authentication-key [encryption-type] key
To delete an authentication key, use the no ip ospf authentication-key command.
Parameters
encryption-type (OPTIONAL) Enter 7 to encrypt the key.
1004
Open Shortest Path First (OSPFv2 and OSPFv3)