Install Guide
Table Of Contents
- Dell EMC PowerSwitch N3200-ON Series Installation Guide
- Contents
- About this guide
- N3200-ON Series switch
- Site preparations
- N3200-ON Series switch installation
- Unpack
- Rack or cabinet hardware installation
- Ground cable
- Desktop
- N3208PX-ON ceiling-mount switch installation
- N3208PX-ON wall-mount switch installation
- Standard bracket two-post installation
- Two-post five-inch-offset switch installation
- Two-post flush-mount switch installation
- Wall- or ceiling-mount switch installation
- One RU ReadyRails installation
- Optics installation
- Switch start-up
- After switch placement
- Switch replacement
- External power adapter
- Power adapter holder assembly
- Wall or ceiling installation
- DIN rail installation
- Single-EPA and switch four-post installation
- Single-EPA and switch two-post center-mount installation
- Single-EPA and switch two-post front-mount installation
- Dual-EPAs two-post front-mount installation
- Dual-EPAs two-post center-mount installation
- Power supply
- Fans
- Management ports
- Installation using ONIE
- Specifications
- Dell EMC support
● Canada: ICES-003, Issue-4, Class A
● Europe: EN55032: CISPR 32: Class A
● International: CISPR 32: Class A
● EN55032
● Japan: VCCI V-3/2011.04, Class A
● Korea: KN32, Class A
● Taiwan: CNS13438, Class A
● USA: FCC CFR47 Part 15, Subpart B, Class A
Immunity
● EN 300 386 v2.1.1 (2016-07) EMC for Network Equipment
● EN 55024 + A1 + A2
● EN 61000-3-2 Harmonic Current Emissions
● EN 61000-3-3 Voltage Fluctuations and Flicker
● EN 61000-4-2 ESD
● EN 61000-4-3 Radiated Immunity
● EN 61000-4-4 EFT
● EN 61000-4-5 Surge
● EN 61000-4-6 Low Frequency Conducted Immunity
● EN 61000-6-1
● EN 61000-4-11 Voltage Dips/Interruptions
Product recycling and disposal
You must recycle or discard this switch according to applicable local and national regulations. Dell EMC encourages owners of
information technology (IT) equipment to responsibly recycle their equipment when it is no longer needed. Dell EMC offers a
variety of product return programs and services in several countries to assist equipment owners in recycling their IT products.
Waste electrical and electronic equipment (WEEE) directive for recovery,
recycle and reuse of IT and telecommunications products
Dell EMC switches are labeled in accordance with European Directive 2002/96/EC concerning waste electrical and electronic
equipment (WEEE). The Directive determines the framework for the return and recycling of used appliances as applicable
throughout the European Union. This label is applied to various products to indicate that the product is not to be thrown away,
but rather reclaimed upon end of life per this Directive.
Figure 11. The European WEEE symbol
In accordance with the European WEEE Directive, electrical and electronic equipment (EEE) is to be collected separately and to
be reused, recycled, or recovered at end of life. Users of EEE with the WEEE marking per Annex IV of the WEEE Directive, as
shown above, must not dispose of end of life EEE as unsorted municipal waste, but use the collection framework available to
customers for the return, recycling and recovery of WEEE. Customer participation is important to minimize any potential effects
of EEE on the environment and human health due to the potential presence of hazardous substances in EEE.
Dell EMC products, which fall within the scope of the WEEE, are labeled with the crossed-out wheelie-bin symbol, as shown
above, as required by WEEE.
For information on Dell EMC product recycling offerings, see the WEEE Recycling instructions on Support. For more
information, contact the Dell EMC Technical Assistance Center.
86
Specifications