Specifications

WARNING: Prevent exposure and contact with hazardous voltages. Do not attempt to operate this switch with
the safety cover removed. To comply with GR-1089 Lightning Criteria for Equipment Interfacing with AC or DC
Power Ports , use an external surge protection device (SPD) at the AC or DC input of the router.
WARNING: Equipment that provides DC input to the DC port must be certified for CCC and meet the relevant
standards.
WARNING: This equipment must be grounded. Connect the power plug to a properly wired earth-ground socket
outlet.
Cautions
CAUTION: Operate the equipment at an ambient temperature not higher than 45°C (113°F).
CAUTION: Stationary pluggable equipment Type-A used in a location with equipotential bonding, such as a
telecommunication center, a dedicated computer room, or a restricted access area, must have installation
instructions that require protective earth-ground connection verification by a skilled electrician.
CAUTION: Illustration of the earth-ground verification Caution in German. Illustration of the power cord Caution
with translations.
Notes
NOTE:
If necessary, to upgrade your software or firmware images, go to the Drivers and Downloads page for your switch
at www.dell.com/support.
NOTE: For proper ventilation, position the switch with a minimum of 12.7 cm (5 in) of clearance around the exhaust vents.
NOTE: Install the switch into a rack or cabinet before installing any additional components such as cables or optics.
NOTE: Dell Technologies recommends you ground your switch. Use the switch in a common bond network (CBN).
Grounding conductors must be made of copper. Copper conductors offer better conductivity and durability. Do not use
aluminum conductors. Coat the one-hole lug with an anti-oxidant compound before crimping. Bring any unplated mating
surfaces to a clean finish and coat with an anti-oxidant before mating.
NOTE: For RoHS information, see Restricted Material Compliance.
NOTE: This device is not intended for use in the direct field of view at visual display workplaces. To avoid incommoding
reflections at visual display workplaces, this device must not be placed in the direct field of view.
4 N2200-ON Series Warnings and Specifications