Setup Guide

Table Of Contents

Figure 18. Attaching the Switch Rails

1 Front standoff locking tab 2 Switch

3 Locking tab

2 After you have installed both switch rails, line them up on the previously mounted ReadyRails and slide the switch in until it is flush

with front of rack. About 3 inches before you fully insert your system, the rail locking feature engages to keep the switch from

inadvertently sliding out of the rack and falling.

NOTE: Do not the use the mounted ReadyRails as a shelf or a workplace.

Figure 19. Installing the N30xx in a Front-Rack Configuration

Switch 2 Rail bracket

3 Mounting screw

Installing as Free-standing Switch

NOTE

: Dell Networking strongly recommends mounting the switch in a rack.

N30xx Series Installation 25