CLI Guide

Layer 2 Switching Commands 872
Examples
The following example displays switchport configuration individually for
gi1/0/1.
switch-top(config-if-Gi1/0/1)#show interfaces switchport gi1/0/1
Port: Gi1/0/1
VLAN Membership Mode: Trunk Mode
Access Mode VLAN: 1 (default)
General Mode PVID: 1 (default)
General Mode Ingress Filtering: Enabled
General Mode Acceptable Frame Type: Admit All
General Mode Dynamically Added VLANs:
General Mode Untagged VLANs: 1
General Mode Tagged VLANs:
General Mode Forbidden VLANs:
Trunking Mode Native VLAN: 1 (default)
Trunking Mode Native VLAN Tagging: Disabled
Trunking Mode VLANs Enabled: 1-99,101-4093
Private VLAN Host Association: none
Private VLAN Mapping:
Private VLAN Operational Bindings:
Default Priority: 0
Protected: Disabled
Forbidden VLANS:
VLAN Name
---- ---------
73 Out
Private-vlan trunk
normal VLANs
Displays a list of normal VLANs for the promiscuous trunk
ports.
Private-vlan trunk
mappings
Displays mappings of all the primary VLANs and their
associated secondary VLANs of promiscuous trunk ports.
Private-vlan trunk
associations
Displays associations of all the primary VLANs and their
associated isolated VLANs of isolated trunk ports.
Operational Private
VLANs
Displays operational private VLANs on this interface.
Parameter Description