CLI Guide

Layer 2 Switching Commands 622
Gi1/0/18 Down Enabled Enabled Disabled 0,1,4
Gi1/0/19 Up Enabled Enabled Disabled 0,1,4
Gi1/0/20 Down Enabled Enabled Disabled 0,1,4
Gi1/0/21 Down Enabled Enabled Disabled 0,1,4
Gi1/0/22 Down Enabled Enabled Disabled 0,1,4
Gi1/0/23 Down Enabled Enabled Disabled 0,1,4
Gi1/0/24 Down Enabled Enabled Disabled 0,1,4
Te1/0/1 Down Enabled Enabled Disabled 0,1,4
Te1/0/2 Down Enabled Enabled Disabled 0,1,4
TLV Codes: 0- Port Description, 1- System Name, 2- System Description
3- System Capabilities, 4- Port VLAN, 5- Management Address
console# show lldp interface Gi1/0/1
Interface Link Transmit Receive Notify TLVs Mgmt
--------- ---- -------- -------- -------- ------- ----
Gi1/0/1 Up Enabled Enabled Enabled 0,1,2,4 Y
TLV Codes: 0 – Port Description, 1 – System Name, 2 – System Description, 3 –
System Capabilities, 4-Port VLAN
show lldp local-device
Use the show lldp local-device command to display the advertised LLDP
local data. This command can display summary information or detail for each
interface.
Syntax
show lldp local-device {detail interface | interface | all}
• detail — includes a detailed version of the local data.
• interface — Specifies a valid Ethernet interface on the device. Specify
either gigabitethernet unit/slot/port or tengigabitethernet unit/slot/port
or fortygigabitethernet unit/slot/port.
• all — Shows lldp local device information on all interfaces.
Default Configuration
This command has no default configuration.