CLI Guide

Layer 3 Routing Commands 1505
Default Configuration
Rate limiting is enabled by default.
The default burst-interval is 1000 milliseconds.
The default burst-size is 100 messages.
Command Mode
Global Configuration mode, Virtual Router Configuration mode
User Guidelines
There are no user guidelines for this command.
When in Virtual Router Configuration mode, this command operates within
the context of the virtual router instance. When in Global Configuration
mode, the command operates on the global router instance.
Virtual Router Configuration mode is only available on the N3000-ON/N3100
switches.
Example
console(config)#ip icmp error-interval 1000 20
ip load-sharing
Use the ip load-sharing command to configure the hash algorithm for ECMP
routes.
Syntax
ip load-sharing mode {inner|outer}
no ip load-sharing
• mode—Load sharing mode (range 1 to 6)
The possible hashing modes are:
1 Source IP address.
2 Destination IP address.
3 Source and destination IP address.
4 Source IP address and source TCP/UDP port number.