Users Guide

Layer 2 Switching Commands 366
console(config)#ipv6 dhcp snooping vlan 5-10,15,30
console(config)#interface Te1/0/1
console(config-if-Te1/0/1)#switchport mode access
console(config-if-Te1/0/1)#switchport access vlan 10
console(config-if-Te1/0/1)#no ipv6 dhcp snooping trust
ipv6 dhcp snooping binding
Use the ipv6 dhcp snooping binding command to configure a static IPv6
DHCP snooping binding. Use the no form of the command to remove the
entry from the binding database.
Syntax
ipv6 dhcp snooping binding mac-address vlan vlan-id ip-address interface
{gigabitethernet unit/slot/port | tengigabitethernet unit/slot/port |
fortygigabitethernet unit/slot/port | port-channel port-channel-number}
no ipv6 dhcp snooping binding mac-address
• mac-address — A valid mac address in standard format.
• vlan-id — A configured VLAN id. (Range 1-4093)
• ip-address — A valid IPv6 address.
• interface-id — A valid Ethernet interface ID in short or long format.
• port-channel-number—A valid port channel identifier.
Default Configuration
By default, no static DHCP bindings are configured.
Command Modes
Global Configuration mode
User Guidelines
Static bindings do not age out of the DHCP binding database.