Users Guide

Switch Management Commands 2201
• vlan-id —A VLAN identifier.
• out-of-band —The out-of-band interface identifier.
Default Configuration
By default, the switch uses the assigned switch IP address. This is either the
IP address assigned to VLAN or the out-of-band interface IP address.
Command Mode
Global Configuration
User Guidelines
This command is not supported on Dell EMC N1100-ON switches. Dell
EMC N1100-ON switches support configuration of a single IP address in
interface vlan configuration mode. That IP address is used as the source
interface address for this function..
Command History
Introduced in version 6.3.0.1 firmware.
Example
console#conf
console(config)#interface vlan 1
console(config-if-vlan1)#ip address dhcp
console(config-if-vlan1)#exit
console(config)#logging source-interface vlan 1
logging traps
Use the logging traps command in Global Configuration mode to set the
lowest severity level at which SNMP traps are logged. To revert the urgent
severity level to its default value, use the no form of this command.
Syntax
logging traps severity
no logging traps