White Papers

73 Using MLAG in Dell Networking N-Series Switches | version 1.5
Te1/0/1 Up
Te1/0/2 Up
VPC id# 60
-----------
Interface................................................ Po60
Configured VLANs............................... 1,30
VPC interface state............................. Active
Local Members Status
----------------- ------
Te1/0/24 Up
Peer Members Status
---------------- ------
Te1/0/24 Up
Te1/0/1 Up
Te1/0/2 Up
VPC id# 60
-----------
Interface................................................ Po60
Configured VLANs............................... 1,30
VPC interface state............................. Active
Local Members Status
----------------- ------
Te1/0/24 Up
Peer Members Status
---------------- ------
Te1/0/24 Up
show vpc brief command output for N4032F MLAG peers in MLAG and VLT
topology
Results of the command should be the same as shown above. All member ports must show Up, and the VPC
interface state must show Active.
The
show interface port-channel is another helpful tool to let you know if the configured LAGs are up and
running. If correctly configured, ports in the primary LAG are listed with an Active status. Inactive ports
indicate a possible cabling or configuration issue.
MLAG peers
show interfaces port-channel 40
Channel Ports Ch-Type Hash Type Min-links Local Prf
------- ----------------------------- -------- --------- --------- ---------
Po40 Active: Te1/0/1, Te1/0/2 Dynamic 7 1 Disabled
show interfaces port-channel 60
Channel Ports Ch-Type Hash Type Min-links Local Prf
------- ----------------------------- -------- --------- --------- ---------
Po60 Active: Te1/0/24 Dynamic 7 1 Disabled
show interface port-channel command output for N4032F-1 in MLAG and VLT
topology
Run show vlt brief and other commands on one of the VLT peers to display information for the VLT
peers. ICL Link, Heartbeat, and VLT peer Status should all show Up.
Results of the command should be similar to what is seen in the following table. The Destination should show
the management IP address of the peer switch, and the peer Heartbeat status should be Up.
Consult the S4810 User Guide or VLT Deployment Guide
for additional information on implementing VLT.