Users Guide

Security Commands 1004
Example
The following example displays information about the 802.1x clients.
console#show dot1x clients all
Clients Authenticated using Monitor Mode....... 1
Clients Authenticated using Dot1x.............. 1
Interface...................................... Gi1/0/2
User Name...................................... 000102030405
Supp MAC Address............................... 00:01:02:03:04:05
Session Time................................... 518
Filter Id......................................
VLAN Assigned.................................. 1
Interface...................................... Gi1/0/7
User Name...................................... dell
Supp MAC Address............................... 00:08:A1:7E:45:1A
Session Time................................... 67
VLAN Assigned.................................. 1
show dot1x interface
This command shows the status and configuration of an IEEE 802.1x
configured interface.
Username The username representing the identity of the Supplicant.
This field shows the username when the port control is
auto or mac-based. If the port is Authorized, it shows the
username of the current user. If the port is unauthorized it
shows the last user that was authenticated successfully.
Supp MAC Address The MAC-address of the supplicant
Session Time The amount of time, in seconds, since the client was
authenticated on the port.
Filter ID The Filter ID assigned to the client by the RADIUS server.
This field is not applicable when the Filter-ID feature is
disabled on the RADIUS server and client.
VLAN Assigned The VLAN assigned to the client by the radius server.
When VLAN assignments are disabled, RADIUS server
does not assign any VLAN to the port, and this field is set
to 0.
Field Description